Before fasteners can be installed in this assembly, it must be constructed and holes prepared.
Learning Objectives
- Recognize fastener location and identification information on an engineering drawing
- Mark fastener locations on the assembly
- Drill pilot holes in an assembly
- Enlarge holes to size
- Take the assembly apart
- Deburr holes in the assembly
Language: English
Estimate Time (Hrs.): 1.1
A Winslow drill motor is used to create the additional holes needed to fasten nut plates to the assembly.
Learning Objectives
- Choose appropriate material for a scrap assembly
- Operate a Winslow drill
- Adjust a Winslow drill
- Install nut plates
Language: English
Estimate Time (Hrs.): 1
Installing rivets with a compression riveter is faster and more consistent than installing rivets with a pneumatic rivet gun.
Learning Objectives
- Use a compression riveter to install rivets in the assembly
Language: English
Estimate Time (Hrs.): 0.8
Bolts are installed using either manual or pneumatic torque tools.
Learning Objectives
- Install bolts with a pneumatic torque tool
Language: English
Estimate Time (Hrs.): 0.7
Lockwire is used to secure bolts and prevent them from loosening. Lockwire can be installed by hand with regular pliers or with lockwire pliers.
Learning Objectives
- Install lockwire using lockwire pliers
Language: English
Estimate Time (Hrs.): 0.8